TM 9-2320-366-20-4
16-11. FENDER AND SPLASH GUARD REPLACEMENT (CONT)
(3) Install nut (6) on hook (7).
(4) Position rear splash guard (8) on bracket (1) with hook
(7), washer (9), plate (10), washer (11), and nut (12).
(5) Position two screws (13), washers (14), and nuts (15) on
bracket (1).
(6) Tighten nut (12) and two nuts (15) to 18-22 lb-ft (24-30
Nm).
g. M1084 Rear Splash Guard Removal.
NOTE
Left and right rear splash guards are
removed the same way. Right side shown.
(1) Remove three nuts (1), washers (2), spacers (3), rods
(4), and rear splash guard (5) from bumper (6) and
fender (7).
(2) Remove three nuts (8) from rods (4).
h. M1084 Rear Splash Guard Installation.
NOTE
Left and right rear splash guards are installed
the same way. Right side shown.
(1) Position three nuts (1) on rods (2).
(2) Position rear splash guard (3) between fender (4) and
bumper (5) with three rods (2), spacers (6), washers (7),
and nuts (8).
(3) Tighten three nuts (8) to 18-22 lb-ft (24-30 Nm).
16-94
Change 1