TM 9-2320-366-20-4
NOTE
Perform steps (12) through (14) on left side.
(12) Position lockwasher (18) and terminal lug TL94 (19) on
front fender (3) with washer (20), screw (21), washer
(22), and self-locking nut (23).
(13) Position three screws (24), six washers (25), and three
self-locking nuts (26) in front fender (3).
(14) Tighten self-locking nut (23) and three self-locking nuts
(26) to 18-22 lb-ft (24-30 Nm).
NOTE
Perform step (15) on right side.
(15) Close cab step tread (27) on cab step (28).
(16) Lower cab (TM 9-2320-366-10-1).
c. Engine Splash Guard Removal.
(1) Raise cab (TM 9-2320-366-10-1).
WARNING
removing rivets. Failure to comply may
result in injury to personnel.
NOTE
Left and right engine splash guards are
removed the same way. Left side shown.
(2) Remove 14 rivets (1), washers (2), and engine splash
guard (3) from cab (4).
16-91