TM 9-2320-366-20-4
16-7. REAR CAB SUPPORT ASSEMBLY REPLACEMENT (CONT)
(13) Lower cab (TM 9-2320-366-10-1).
CAUTION
Latches must be adjusted so that they ride
squarely on the latch supports and do not
contact the welded area of the latch supports.
Failure to comply may result in damage to
equipment.
(14) Adjust two latches (14) on latch supports (15).
(15) Raise cab (TM 9-2320-366-10-1).
CAUTION
Do not allow latches to change position while
tightening screws. Failure to comply may
result in damage to equipment.
(16) Tighten four screws (13) to 34-44 lb-ft (46-60 Nm).
(17) Lower cab (TM 9-2320-366-10-1).
(18) Inflate cab air springs (TM 9-2320-366-10-1).
NOTE
Perform step (19) on left and right sides of cab
rear support.
Step (19) requires the aid of an assistant.
(19) Tighten four self-locking nuts (16) to 45-61 lb-ft (61-83
Nm).
c. Follow-On Maintenance.
(1) Adjust cab hydraulic latch (para 19-7).
End of Task.
16-62
Change 1