TM 9-2320-366-20-4
(5) Remove connector cover (12) from remote control cable
connector (13).
(6) Remove nut (14), screw (15), connector cover (12), and
lanyards (16 and 17) from support structure (18).
NOTE
Note routing of cable assembly prior to
removal.
(7) Remove four nuts (19), screws (20), and remote control
cable assembly (21) from vehicle.
b. Installation.
(1) Install remote control cable assembly (1) on vehicle with
four screws (2) and nuts (3).
(2) Install lanyards (4 and 5) on support structure (6) with
screw (7) and nut (8).
(3) Install connector cover (9) on remote control cable
connector (10).
NOTE
Install plastic cable ties as required.
(4) Position 17 electrical wires (11) on terminal board (12) at
positions 2, 3, 4, 6, 7a, 8, 9, and 10 through 19.
(5) Tighten 17 screws (13) on terminal board (12) at
positions 2, 3, 4, 6, 7a, 8, 9, and 10 through 19.
7-583