TM 9-2320-272-24-3
4-209. TRANSMISSION POWER TAKEOFF (PTO) CONTROL CABLE REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
TM 9-2320-272-10
M925, M928, M929, M930, M932, M936
TM 9-2320-272-24P
TOOLS
General mechanic's tool kit (Appendix E, Item 1)
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-272- 10).
MATERIALS/PARTS
Cotter pin. (Appendix D, Item 84)
Four locknuts (Appendix D, Item 307)
Cotter pin (Appendix D, Item 66)
a. Removal
1.
Open transmission dipstick access door (1) inside of cab (TM 9-2320-272-10)
2.
Remove two locknuts (2), screws (5), clamp (6), and spacer plate (4) from PTO cable bracket (3).
Discard locknuts (2).
3.
Remove cotter pin (11) and washer (10) and lift PTO cable pin (8) free of select lever (9). Discard
cotter pin (11).
4.
Remove PTO cable pin (8) from PTO cable (7).
NOTE
Tag all ends of PTO cable for installation.
5.
Remove six screws (20) and access cover (19) from PTO control panel (12).
6.
Remove two locknuts (18), screws (14), clamp (17), and spacer (16) from PTO control panel (12).
Discard locknuts (18).
7.
Remove cotter pin (22), washer (23), and clevis pin (25) from PTO control lever (13), and pull end of
control cable (7) clear of PTO control panel (12). Discard cotter pin (22).
8.
Loosen nut (21) on PTO control cable (7) and remove cable clevis (24).
9.
Pull PTO control cable (7) on PTO control panel (12) through grommet (15) and into cab.
b. Installation
1.
Feed transmission select lever end of PTO control cable (7) through rear of PTO control panel (12)
and into grommet (15).
2.
Attach PTO cable clevis (24) to PTO control panel end of cable (7) with nut (21).
3.
Install PTO cable clevis (24) on PTO control lever (13) with clevis pin (25), washer (23), and new
cotter pin (22).
4.
Install PTO control cable (7) on PTO control panel (12) with two screws (14), spacer (16), clamp (17),
and two new locknuts (18).
5.
Install PTO control panel access cover (19) on PTO control panel (12) with six screws (20).
6.
Pull PTO control cable (7) down to PTO from engine compartment and install PTO cable pin (8) on
end of PTO control cable (7).
7.
Connect PTO cable pin (8) to PTO select lever (9) with washer (10) and new cotter pin (11).
8.
Attach PTO control cable (7) to PTO cable bracket (3) with clamp (6), spacer plate (4), two
screws (5), and new locknuts (2).
4-976