TM 9-2320-272-24-3
4-155. HINGED END PANEL MAINTENANCE
THIS TASK COVERS:
d. Assembly
a. Removal
e. Installation
b. D i s a s s e m b l y
c. Cleaning and Inspection
INITIAL SETUP:
PERSONNEL REQUIRED
APPLICABLE MODELS
M934/A1/A2
Two
MANUAL REFERENCES (TM)
TOOLS
TM 9-2320-272-10
General mechanic's tool kit (Appendix E, Item 1)
TM 9-2320-272-24P
MATERIALS/PARTS
EQUIPMENT CONDITION
Seal (35 in.) (Appendix D, Item 632)
l Parking brake set (TM 9-2320-272-10).
Seal (35 in.) (Appendix D, Item 633)
l Van body sides fully extended and secured
Seal (35 in.) (Appendix D, Item 606)
(TM 9-2320-272-10).
Twelve rivets (Appendix D, Item 546)
Eighteen rivets (Appendix D, Item 547)
Caulking compound (Appendix C, Item 15)
NOTE
All hinged end panels are removed the same way This procedure
covers the left rear hinged end panel.
1.
Remove sixteen screws (18) from end panel hinge (21) and side panel (20).
NOTE
Assistant will help with step 2.
2.
Remove panel frame (7) as an assembly from side panel (20).
b. Disassembly
1.
Remove sixteen screws (19), hinge (21), and seal (22) from panel frame (7). Discard seal (22).
2.
Remove twenty-seven screws (8), retainer (10), and seal (9) from panel frame (7). Discard seal (9).
3.
Remove ten screws (1), retainers (2) and (3), and seal (4) from channel (5). Discard seal (4).
4.
Remove eighteen rivets (6), twenty screws (17), and channels (5) and (16) from outer skin (12) and
inner skin (24). Discard rivets (6).
5.
Remove two screws (15), strap (14), and spacer plate (13) from outer skin (12).
NOTE
l Perform steps 6 and 7 only if skins are to be replaced. See task c.
l Assistant will help with steps 6 and 7.
6.
Remove twelve rivets (11) and outer skin (12) from panel frame (7). Discard rivets (11).
7.
Remove thirty screws (25), eighteen screws (23), and inner skin (24) from panel frame (7).
4-762