TM 9-2320-272-24-2
34.
Remove nut (6), coupling (5), and gasket (7) from adapter (4) and exhaust manifold (8). Discard
gasket (7).
35.
Remove two screws (12), washers (11). bracket assembly (10), and exhaust brake assembly (13) from
engine block (9).
Remove nut (14), clamp (2), adapter (4). and gasket (1) from exhaust brake assembly (13). Discard
36.
gasket (1).
Remove two screws (16), washers (15), and exhaust brake assembly (13) from bracket assembly (10).
37.
Remove elbow (19) from quick-release valve (20) and exhaust brake assembly (13).
38.
Remove tube (17) and elbow (18) from exhaust brake assembly (13).
39.
NOTE
Apply sealant to male threads of fittings and leave first two
starter threads clear of sealant.
It may be necessary to make adjustments to fittings for
alignment purposes.
Do not tighten exhaust components until exhaust system is
completely assembled except for steps 5 and 7.
Ensure antiseize tape is applied to any screws attached to
engine assembly.
1.
Install elbow (18) and tube (17) on exhaust brake assembly (13).
2.
Install elbow (19) on quick-release valve (20) and exhaust brake assembly (13).
3.
Install exhaust brake assembly (13) on bracket assembly (10) with two washers (15) and screws (16).
4.
Install new gasket (1) and adapter (4) on exhaust brake assembly (13) with adapter (4) reference
line (3) at 3 O'clock position as viewed from driver's seat and install clamp (2) and nut (14).
5.
Install exhaust brake assembly (13) and bracket assembly (10) on engine block (9) with two
washers (11) and screws (12).
6.
Install new gasket (7) and coupling (5) on adapter (4) and exhaust manifold (8) with nut (6).
3-1194