TM 9-2320-272-24-2
3-277. WINDSHIELD WIPER BLADE, WIPER ARM, AND WIPER MOTOR REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
Torque wrench (Appendix E, Item 146)
Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
GENERAL SAFETY INSTRUCTIONS
Two locknuts (Appendix D, Item 292)
Locknut (Appendix D, Item 293)
Do not disconnect air lines before draining air
Leather washer (Appendix D, Item 269)
reservoirs.
Lockwasher (Appendix D, Item 367)
Antiseize tape (Appendix C, Item 72)
Cap and plug set (Appendix C, Item 14)
WARNING
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
CAUTION
Cap or plug all openings immediately after disconnecting lines or
system damage or injury to personnel.
1.
Remove locknut (10), screw (11), and wiper blade (12) from wiper arm (7). Discard locknut (10).
NOTE
Mark position of wiper arm for installation.
2.
Remove nut (9), lockwasher (8), and wiper arm (7) from wiper motor shaft (1). Discard lockwasher (8).
3.
Remove knurled drive (6) from wiper motor shaft (1).
Remove nut (5), washer (4), and leather washer (3) from wiper motor shaft (1). Discard leather
4.
washer (3).
Remove hose clamps (14) and (17) and hoses (15) and (16) from adapter fittings (22) and (21).
5.
Remove two locknuts (20), screws (18), wiper motor (13), and wiper motor bracket (19) from
6.
windshield frame (2). Discard locknuts (20).
Remove two screws (25), bracket (19), and two spacers (24) from wiper motor (13).
7.
Remove adapter fittings (21) and (22) from wiper motor (13).
8.
Remove muffler (23) from wiper motor (13).
9.
3-748