• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
PRIMARY AND SECONDARY LOW AIR PRESSURE SWITCH REPLACEMENT cont'd - TM-9-2320-272-24-10643
SPRING BRAKE PRESSURE SWITCH REPLACEMENT cont'd

TM-9-2320-272-24-1 Truck 5-Ton 6x6 M939 M939A1 M939A2 Series Trucks (Diesel) Manual
Page Navigation
  624    625    626    627    628  629  630    631    632    633    634  
TM 9-2320-272-24-1
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP:
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-272-10
All
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's too1 kit (Appendix E, Item 1)
Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
Air reservoirs drained (TM 9-2320-272-10).
Antiseize tape (Appendix C, Item 72)
Battery ground cables disconnected (para. 3-126).
GENERAL SAFETY INSTRUCTIONS
Do not disconnect air lines before draining air
reservoirs.
WARNING
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
1.
Remove eight screws (3) from instrument cluster (2).
2.
Pull instrument cluster (2) away from instrument panel (1).
3.
Disconnect two wires (8) from spring brake pressure switch (7).
4.
Remove spring brake pressure switch (7), fitting (6), and elbow (5) from spring brake release control
valve (4).
NOTE
Male pipe threads must be wrapped with antiseize tape before
installation.
1.
Install elbow (5), fitting (6), and spring brake pressure switch (7) on spring brake release control
valve (4).
2.
Connect two wires (8) to spring brake pressure switch (7).
3.
Install instrument cluster (2) on instrument panel (1) with eight screws (3).
3-278






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.