TM
9-2320-260-34-1
8-5. TRANSMISSION (OUT-OF-VEHICLE) REPLACEMENT (Contd)
b. Installation
NOTE
Steps 1 and 2 apply to transmissions equipped with transmis-
sion power takeoff (PTO).
Perform step 1 if stud(s) was removed.
1. Install stud(s) (1) in transmission (6).
2. Install new gasket (5) and PTO (4) on transmission (6) with six new lockwashers (2) and nuts (3).
3. Remove safety strap from transmission (6).
WARNING
Transmission lifting jack must have a weight capacity greater
than the weight of the transmission to prevent damage to equip-
ment and injury to personnel.
NOTE
Apply gasket sealant to gasket before installation.
4. Using transmission lifting jack, position transmission (6) on flywheel housing (10) and install
new gasket (7) and transmission (6) on flywheel housing (10) with twelve new lockwashers (8) and
screws (9). Tighten screws (9) 25-31 lb-ft (34-42
5. Remove transmission lifting jack from under transmission (6).
8-12