TM 9-2320-260-20
14-56. CONVOY
WARNING LIGHT HARNESS (M820, M820A1, M820A2)
REPLACEMENT
THIS TASK COVERS:
a.
Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
M820, M820A1, M820A2
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Seven screw-assembled lockwashers
Locknut
Parking brake set (TM 9-2320-260-10).
1.
Remove two tiedown straps (3) and harness (4) from support tubes (2) and van body (1). Discard
tiedown straps (3).
2. Remove twenty-five screw-assembled washers (5), clamps (6), and harness (4) from van body (1).
3. Remove four screw-assembled lockwashers (19), washers (20), clamps (21), and harness (4) from
van body (1). Discard screw-assembled lockwashers (19).
4. Remove five screw-assembled washers (18), clamps (17), and harness (4) from van body (1).
5. Remove three screw-assembled lockwashers (14), washers (15), clamps (16), and harness (4) from
van body (1). Discard screw-assembled lockwashers (14).
6. Disconnect lead (13) from wire (12).
7. Remove locknut (11), screw (7), two washers (9), and ground lead (8) from fuel tank support (10).
Discard locknut (11).
1.
Connect lead (13) of harness (4) to wire (12).
2.
Install ground lead (8) of harness (4) to fuel tank support (10) with two washers (9), screw (7),
and new locknut (11).
3.
Route harness (4) to front of van body (1).
4.
Install harness (4) on van body (1) with three clamps (16), washers (15), and new screw-assembled
lockwashers (14).
Install harness (4) on van body (1) with five clamps (17) and screw-assembled washers (18).
5.
Route harness (4) to top of van body (1).
6.
Install harness (4) on van body (1) with four clamps (21), washers (20), and new screw-assembled
7.
lockwashers (19).
Route harness (4) to rear of van body (1).
8.
Install harness (4) on van body (1) with twenty-five clamps (6) and screw-assembled washers (5).
9.
Install harness (4) on support tubes (2) with two new tiedown straps (3).
10.
14-108