TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
M816
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Four locknuts
Parking brake set (TM 9-2320-260-10).
1. Loosen two clamps (6) and slide boots (7) and (10) toward middle of propeller shafts (8) and (9).
2. Remove four locknuts (12) and screws (11) from propeller shafts (8) and (9). Discard locknuts (12).
3. Remove propeller shaft (9) from power divider (1).
4. Remove boot (10) from propeller shaft (9).
5. Remove six screws (13), bearing (5), and propeller shaft (8) from bevel gear (2).
6. Remove boot (7) from propeller shaft (8).
7. Remove screw (4), washer (3), and bearing (5) from propeller shaft (8).
1.
Install bearing (5) on propeller shaft (8) with washer (3) and screw (4).
2.
Install boot (7) on propeller shaft (8).
Install bearing (5) and propeller shaft (8) on bevel gear (2) with six screws (13).
3.
Install boot (10) on propeller shaft (9).
4.
5.
Position propeller shaft (9) on power divider (1).
6.
Install propeller shaft (9) on propeller shaft (8) with four screws (11) and new locknuts (12).
7.
Position front boot (10) on power divider (1) and rear boot (7) on bevel gear (2).
Tighten two clamps (6) on boots (7) and (10).
8.
13-130
