TM 9-2320-260-20
12-51. TAILLIGHT BRACKET REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
M816
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Two screw-assembled lockwashers
Four lockwashers
Parking brake set (TM 9-2320-260-10).
Two locknuts
a. Removal
NOTE
Left and right taillight brackets are replaced the same way. This
procedure covers the right taillight bracket.
Tag all wires for installation.
1. Remove two nuts (6), lockwashers (7), screws (9), and reflector (8) from taillight guard (4). Discard
lockwashers (7).
2. Remove four screws (5) and taillight guard (4) from bracket (11).
3. Disconnect four leads (12) from wires (10).
4. Remove two screw-assembled lockwashers (3) and housing (13) from bracket (11). Discard screw-
5. Remove two locknuts (14), lockwashers (15), screws (2), and bracket (11) from ladder bracket (1).
Discard locknuts (14) and lockwashers (15).
b. Installation
1. Install bracket (11) on ladder bracket (1) with two screws (2), new lockwashers (15), and new
locknuts (14).
2. Install housing (13) on bracket (11) with two new screw-assembled lockwashers (3).
3. Insert four leads (12) through hole in bracket (11) and connect to four wires (10).
4. Install taillight guard (4) on bracket (11) with four screws (5).
5. Install reflector (8) on taillight guard (4) with two screws (9), new lockwashers (7), and nuts (6).
12-106