TM 11-7440-293-14
4-65. REMOVING/lNSTALLING ANGLE BRACKETS ON PP-1104 POWER SUPPLY.
This task covers:
1. Removal
2. Installation
INITIAL SETUP
Personnel Required
Tools
One mechanic
Pliers
1/2-inch box wrench
Equipment Condition
Flat-tip screwdriver
All power in vehicle off. Guard
Materials/Parts
assembly removed. (See
None
ACTION
REMARKS
ITEM
LOCATION
REMOVAL
Using pliers, remove.
1. Front of power
Wingnuts (1)
Remove.
2.
DC/DC switch
Remove both wires. Do not remove
power cable (2)
10-inch electrical lead unless
replacement is required.
Screw (3), lock-
3. Front angle
Using 1/2-inch box wrench, remove.
There are three screws per angle
washer (4) and
bracket
flat washer (5)
bracket. Step 5 is typical for all
three screws.
Do step 5 again.
4.
Screws (6)
Rear angle
Do steps 5 and 6 for rear angle bracket.
5. Rear of power
bracket (7)
supply
Remove.
Power supply (8)
6. Curbside, near
forward wall
4-124