TM 11-7440-293-14
4-58. CONNECTING POWER CABLE TO POWER SUPPLY.
This task covers:
Installation
INITIAL SETUP
Personnel Required
Tools
One mechanic
Wire cutters
Flat-tip screwdriver
Equipment Condition
Wire strippers
Power cable installed in outlet box
Materials/Parts
on rear of power supply.
Power cable, 1-foot section
ACTION
REMARKS
ITEM
LOCATION
Remove.
Side panel (1)
1.
Curbside of
power supply
Left-hand connec-
Black wire (2) and
Using flat-tip screwdriver, install.
2.
screw (3)
tions on power
supply terminal
board
Using flat-tip screwdriver, install.
White wire (4) and
3.
screw (5)
NOTE
Use 1-foot piece of power cable. Remove outer insulation and
use either one or two wires. For 115 volt hook up, use two
wires.
Any two wires
Using wire strippers, strip 5/8 inch of
Wire (6) and
4.
insulation from each wire.
wire (7)
from 1-foot
If needed, cut wires to desired
power cable
length for installation.
Using flat-tip screwdriver, install.
Wire (6), screws
Right side of
5.
(8), wire (7) and
terminal board
screws (9)
4-108