TM 11-7440-293-14
4-17. PP-4763 POWER SUPPLY MOUNTING HOLES.
This task covers:
INITIAL SETUP
Tools
Personnel Required
Felt-tip pen
One mechanic
Tape measure
Equipment Condition
Materials/parts
Angle brackets installed
Power supply
on power supply.
ACTION
LOCATION
ITEM
REMARKS
NOTE
Set power supply 5 3/4 inches from curbside edge of floor
plate and 7-3/4 inches from forward wall. The angle bracket
mounting holes will be used as guides for marking.
1. Curbside of
Mark (1)
Using felt-tip pen, mark.
power supply
There are two angle brackets. Each
angle bracket has three mounting holes.
Step 1 is typical for all six
mounting holes.
2. Roadside of
Marks (2)
Do step 1 again.
Power supply
4-26