CARGO BED COVER (CBC), TYPE IV, 5 T CARGO TRUCK, MTV, AND MTV TRAILER
REPLACING WINCH CORNER CABLE ASSEMBLY
The following procedure applies only to the replacement of the short cable assembly located at the winch
corner. To replace any of the other cable assemblies, refer to the section of this work package entitled
"REPLACING CABLE ASSEMBLIES OTHER THAN THE WINCH CORNER".
Once the cables are unwound and completely disconnected from the winch barrel, remove the corner
pulley cover plate (1) by removing the two screws (2,6) that secure it in place. Note that the screw (2)
closest to the winch has a spacer (3) and is secured with a locknut (4).
Lift and remove the right hand pulley (5) and set it aside.