CARGO BED COVER (CBC), TYPE IV, 5 T CARGO TRUCK, MTV, AND MTV TRAILER
CARRIER MOUNTING ANGLE
THIS SECTION COVERS:
Personnel Required: One
Maintenance Level - Unit
Tools and Special Tools
This procedure contains information and instructions to keep the CBC safe and in good working order by
inspecting and replacing a defective carrier mounting angle.
Inspect the carrier mounting angle (1) to ensure that all securing hardware is in place and that there are
no cracks, bends, or otherwise damaged parts that would prevent the carrier mounting angle from
properly securing the CBC to the mounting plate or the vehicle bed.
Also inspect the condition of the CBC sidewall to ensure that it was not damaged in such a way as to
prevent the proper installation of a new carrier mounting angle. If the sidewall is damaged, it must be
repaired in accordance with the work packages in this manual dealing with sidewall repair.
To remove a damaged carrier mounting angle (1), remove all hex bolts (2), lock washers (3), and flat
washers (4) that are securing the damaged carrier mounting angle.
Remove the damaged carrier mounting angle (1).
Install the new carrier mounting angle by aligning the holes (5) in the angle with the holes (6) on the side
wall (7) of the CBC.
Install hex bolts (2), lock washers (3), and flat washers (4) in all mounting holes.