CARGO BED COVER (CBC), TYPE IV, 5 T CARGO TRUCK, MTV, AND MTV TRAILER
Slowly rotate the winch barrel (7) approximately 1/2 turn in order to position the keyhole (9) located on the
left end plate (10) at the top of the winch barrel.
Install the left winch corner cable assembly (17) back onto the winch barrel (7) by inserting its ball end (8)
into the key-hole slot (9) located in the outside (10) plate of the winch barrel (7). It may require some force
to pull and/or push the end ball through the keyhole slot.
Using the ratchet, carefully wind the cables (16,17) onto the winch barrel (7). Make sure the cable ball
ends (8) are firmly against the end of the small part of the key-hole slots (9) and remain parallel to one
another and in a single layer as they wind onto the barrel.
Install the winch cover (2) by installing the four screws (3), lockwashers (4), and flat washers (5) that
secure the cover (2).
Raise and lower the CBC upper section 2 to 3 times in order to re-tension the cables.
Note: Reverse the installation of the bolts
at this location.
NOTE: This illustration continues on the next page