CARGO BED COVER (CBC), TYPE IV, 5 T CARGO TRUCK, MTV, AND MTV TRAILER
Marking the location of the carrier mounting angle holes. The bottom edge of the lower section of the
Cargo Bed Cover is attached to the vehicle bed by means of a series of carrier mounting angles (1).
These angles and threshold have a total of 27 predrilled mounting holes where only 19 of the holes (2)
To transfer the position of the carrier mounting holes to the vehicle bed, use the 3/8 inch transfer punch
(3) supplied with the mounting kit and mark the vehicle bed in 19 places. There are 4 holes each in the
carrier mounting angles at the front (4), left (5), and right sides (6) of the CBC. There are two holes in
each of the two smaller carrier mounting angles (7) at the rear of the CBC located on either side of the
door opening and a total of 3 holes in the threshold.
Once all 19 hole positions have been marked, the CBC can be removed from the vehicle bed and
returned to its shipping pallet while the holes are drilled in the vehicle bed and Rivnuts installed.
4 Vehicle cab
of CBC and
NOTE: Only those carrier
mounting angle holes
indicated on this drawing
by a short arrow on the
inside of the CBC require
holes shown on the side
carrier mounting angles
and Rivnut installation.