CARGO BED COVER (CBC), TYPE IV, 5 T CARGO TRUCK, MTV, AND MTV TRAILER
OPERATION UNDER USUAL CONDITIONS
Stowing the lower personnel door panel. The lower personnel door panel (1) is stowed on the
underside of the roof (2) when the CBC is to be retracted.
Once the lower personnel door has been removed and the hinge (3) transferred to the inside surface of
the door panel, stand under the two "Z" brackets (4) installed just inside the personnel door opening.
While holding the lower door panel at an angle (5), slide the bottom edge (6) of the lower door panel
inside the right hand "Zee" bracket (7) just to the right of the rubber strip (8) installed on the roof surface.
Make sure that the side of the door with the hinge installed (inside surface of door) is facing the floor of
the CBC when installed in the bracket.
While holding the panel in place in the right hand bracket (7), swing the upper edge (9) of the door panel
into position against the left hand "Zee" bracket (10), aligning the holes on the door panel tabs (11) with
the threaded inserts installed in the left hand bracket (10).
When installing the three hand knobs, avoid cross threading. Damage to
threaded studs may occur.
Install the three hand knobs with threaded studs (12) and lockwashers (13) that were removed when
disassembling the personnel door. Take care not to cross-thread the hand knobs into the threaded studs.